Laurel-electronics Ethernet Node Configuration for Series 2 Digital P Uživatelský manuál stáhnout pdf (Strana 26)

8. EMAIL ACCOUNT TAB

A Node must have its own email account so that it can send and receive emails.

Node's E-Mail Address. Enter a unique email address for the Node so that it can receive email,

then press on “Put”. That address will also be shown as the sender in emails from the Node.

Server Information (Names). Enter names for the Incoming Mail (POP3) and Outgoing Mail

(SMTP) servers for the Node. This information should be the same as for other email clients

on the same network. In MS Outlook, it is found under Tools > E-mail Accounts. It should also

be available from the network administrator or company IT department.

Advanced User Checkboxes. If desired, IP addresses can be entered instead of names for the

Incoming Mail (POP3) and Outgoing Mail (SMTP) servers, and server ports can be changed

from their default settings. Standards are Port 110 for Incoming Mail and Port 25 for Outgoing

Mail. While Outgoing Port 25 is the standard for sending email, it is also often used for

sending spam, so Internet Service Providers may block it. If blocked, try Port 2525 or Port

587.

Note: Only one instance of Node Manager can connect to the same Node at the same time.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Žádné komentáře

Laurel-electronics Ethernet Node Configuration for Series 2 Digital P Uživatelský manuál Strana 26